BWI Eagle AIR-EAGLE XLT Manual
900 mhz rf transmitter
Hide thumbs
Also See for AIR-EAGLE XLT:
- Manual (10 pages) ,
- Product information bulletin (4 pages) ,
- Product information bulletin (3 pages)
Related Manuals for BWI Eagle AIR-EAGLE XLT
Summary of Contents for BWI Eagle AIR-EAGLE XLT
- Page 1 AIR-EAGLE XLT 441P-HH-9-003 900 MHz RF Transmitter Document Date: 7/28/2023 Product Rev: 12...
-
Page 2: Warranty Statement
441P-HH-9-003 WARRANTY STATEMENT BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly used and installed, will be free from defects in material and workmanship for a period of 1 year after date of purchase. Said warranty to include the repair or replacement of defective equipment. This warranty does not cover damage due to external causes, including accident, problems with electrical power, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation, or improper testing. -
Page 3: Controls And Indicators
441P-HH-9-003 INTRODUCTION The Air-Eagle XLT TX is a handheld R.F. transmitter capable of sending up to eight unique digital commands to an Air-Eagle XLT Receiver located up to 2500 feet away. Eight user-programmable frequencies allow multiple systems to operate simultaneously in the same area without interference. This transmitter will automatically go into “sleep”... -
Page 4: General Operation
441P-HH-9-003 GENERAL OPERATION Each of the first six buttons operates a gate at a road. Buttons are labeled with the road names as follows: Button 1 – Johnson North Button 2 – Cleveland Button 3 – Sherman Button 4 – Johnson South Button 5 –... -
Page 5: Frequency Programming
441P-HH-9-003 FREQUENCY PROGRAMMING Please read through these instructions completely before beginning programming procedure! At any time, you can check the current frequency setting by depressing the P/Shift button, for approximately 5 seconds, until the TX LED is illuminated RED. Then release the P/Shift button and watch as the TX LED stays RED for about 10 seconds, goes out, then begins to blink. -
Page 6: Specifications
441P-HH-9-003 SPECIFICATIONS Durable Sealed Membrane Keypad – Eliminates Dust, Dirt and Keypad Moisture Failures Enclosure ABS UL94 HB Enclosure with ring is rated IP54 *Not Waterproof Protective Ring SEBS (TPE) Power Requirements 3.0 VDC (2) 1.5V lithium each, size AA, to equal 3.0VDC nominal. ***For Battery Type best performance use ONLY Energizer Brand Lithium Batteries *Note: Current frequency settings are maintained in flash memory during battery...