BWI Eagle AIR-EAGLE XLT Product Information Bulletin

AIR-EAGLE
900 MHz RF Transmitter
MODEL 441P-12-ESTOP-120VAC
DESCRIPTION
The A -E XLT, 441P-12-ESTOP-120VAC is an R.F.
IR AGLE MODEL
transmitter designed to work with the model 441P-8-ESTOP receiver
for failsafe emergency stop of any electrical apparatus. This transmitter
has been factory programmed to emit a beacon signal that keeps the
relays in the remote receiver energized. This provides a "handshake
link" between the two units that if lost will automatically de-energize the
E-Stop relay and shut down the equipment. While linked, pressing the
E-Stop button will immediately de-energize the E-Stop relay. This
transmitter is capable of reaching the receiver from up to 2500 feet (or
more w/external high gain antennas) away and has seven user-
selectable network frequencies to allow multiple systems to operate
simultaneously in the same area without interference.
INSTALLATION
1. Mount the A -E XLT TRANSMITTER in a convenient location
IR AGLE
where the operator will have easy access to the stop button.
2. Install antenna onto antenna connector located on the right side on
the enclosure.
3. Plug supplied AC to DC wall plug adapter into AC outlet.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1 2 3 4 5
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
XLT
6 7 8 9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 4.3" H
CONTROLS & INDICATORS
PWR/TX LED
Beacon Emission
STOP Pushbutton
FREQUENCY SET-UP
This transmitter is factory set to Frequency #1. This setting can be
changed by the user at any time by following the directions below:
1) Remove power from unit
2) Remove top cover.
3) Select desired network frequency using table below.
4) Reattach cover and apply power.
5) Programming is now complete.
SEL 2 (SW 1-3):
(NETWORK
FREQUENCY)
10
SEL2 (SW4)
BULLETIN
Illuminates green continuously while power
is applied. Changes to red when transmitting
data.
Invisible to the user this unit transmits a
beacon signal every .1 seconds to keep the
remote relays energized
Transmits CH1 RF "STOP" code to receiver
Network SW1 SW2
Frequency
1 (default) OPEN OPEN
2 CLOSED OPEN
3 OPEN CLOSED
4 CLOSED CLOSED
5 OPEN OPEN
6 CLOSED OPEN
7 OPEN CLOSED
Reserved for future use
SW3
OPEN
OPEN
OPEN
OPEN
CLOSED
CLOSED
CLOSED