BWI Eagle AIR-EAGLE XLT Product Information Bulletin

AIR-EAGLE
900MHz RF Receiver
MODEL 44UL-20800-DC
DESCRIPTION
The A -E XLT is a UL/CSA approved RF system designed for
IR AGLE
medium to long range wireless remote control of electrical apparatus in a
variety of industrial applications. Systems can consist of any number of
receivers and handheld or contact input transmitters working together.
This receiver is equipped with 8 independent relays that can switch 5
amps @ 120VAC or 30VDC. The relays are user programmable for
momentary or toggle/latching operation and can be directly interfaced with
the customer's equipment or P.L.C. Seven user selectable frequencies
allow multiple systems to be used in the same area. Capable of receiving
remote signals transmitted from up to 2500 feet away (with the handheld
transmitter) or up to 4 miles away (with the contact input transmitter), the
Air-Eagle XLT utilizes spread-spectrum technology and provides the
utmost security and reliability even in the noisiest RF environments.
Please read through this document in its entirety before proceeding
with installation.
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1. Mount the control unit in a suitable location that allows the user to
easily remove the lid of the enclosure for wiring access. When
possible select a location that is not directly beside high energy
transformers or large inductive relay housings. It is recommended to
allow for a minimum of 2.0" clearance on all sides of the unit's
housing & mounting plate. The power and control wiring exiting thru
the provided cord grips should have ample room to bend without
excessive stress. It is also important that any coax cable connected
to the TNC connector have room to bend without "kinking".
2. Install relay wiring to terminal strip (TER2).
3. Attach supplied rubber duck antenna to TNC connector on the right
side of the unit.
4. Connect DC power to the proper terminals in your control circuit.
Note 1: (4) 1/4-20 thru holes are provided on the mounting feet to secure
the unit)
Note 2: The recommended power/control wire sizes to the terminal strip
ranges from 24 AWG (0.205mm2) (min) to 18 AWG (0.823mm2) (max).
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
® XLT
PRODUCT INFORMATION
BULLETIN
TERMINAL STRIP WIRING (TER2)
1 N/O Relay #1 10 N/O Relay #4
2 C Relay #1 11 C Relay #4
3 N/C Relay #1 12 N/C Relay #4
4 N/O Relay #2 13 N/O Relay #5
5 C Relay #2 14 C Relay #5
6 N/C Relay #2 15 N/C Relay #5
7 N/O Relay #3 16 N/O Relay #6
8 C Relay #3 17 C Relay #6
9 N/C Relay #3 18 N/C Relay #6
DC INPUT (TER1)
Terminal #1
Terminal #2
19 N/O Relay #7
20 C Relay #7
21 N/C Relay #7
22 N/O Relay #8
23 C Relay #8
24 N/C Relay #8
Negative (-) 10 – 24 VDC INPUT
Positive (+) 10 – 24 VDC INPUT
Page 1