Moving Or Transporting The Product; Prepare To Move The Product; Setting Up The Product After Moving - Epson SureColor F6370 User Manual

Moving or Transporting the Product

When moving the product, see these sections to prepare and move the product, and set it back up after
moving it.
If you need to transport the product a long distance, contact Epson support.

Prepare to Move the Product

Setting Up the Product After Moving

Prepare to Move the Product
Do the following before moving the product:
1. Remove any loaded media from the feeding unit and auto take-up reel, if installed.
2. Turn off the product.
3. Remove the waste ink bottle.
4. Remove all cables.
5. Release the locks on the product stand.
Caution: Do not try to move the stand while the casters are locked. Roll the product for only a short
distance over a level floor. Do not tilt the product more than 10° in any direction or the product may fall
over.
Parent topic:
Related tasks
Replacing the Waste Ink Bottle
Removing Media
Setting Up the Product After Moving
Follow these steps to set up the product after moving it.
1. Verify that the location is suitable for installation.
2. Install the waste ink bottle.
3. Connect the power cable to an electrical outlet and turn on the printer.
4. Load media in the product.
Moving or Transporting the Product
108