Table of Contents
Advertisement
Step 4: Turn the output on
Turn the output on by pressing the OUTPUT ON/OFF
control
. The ON/OFF indicator LED lights and
measurements begin.
Step 5: Observe measurements
Observe the measured voltage on the main area of
front-panel display. The readings should be very close to the
20 V source value.
Step 6: Turn the output off
When you finish making measurements, turn the output
off by pressing the OUTPUT ON/OFF
output indicator LED turns off.
NOTE
These steps confirm basic functionality of your instrument.
Turn the instrument power OFF now.
To use the pulser feature, you must have remote
communications set up. Refer to the Model
2601B-PULSE Reference Manual (document number
2601B-PULSE-901-01) for information on remote
communications setup.
control. The
Advertisement
Table of Contents
Need help?
Do you have a question about the Keithley System SourceMeter 2601B-PULSE and is the answer not in the manual?