Output Values - BONFIGLIOLI Vectron ACTIVE CUBE Applications Manual

Voorhout • Groningen • Weert • Hoogerheide
Gear factor
Gear Factor Numerator at Dmin
Parameters
the numerator and denominator of the gear factor at minimum diameter.
Parameter
No. Identifier
Gear Factor Numerator at Dmin
832
Gear Factor Denominator at Dmin
833
Percentage source
After multiplication by a fixed gear factor, the input value is multiplied by a diameter-dependent per-
centage from Parameter
Parameter
No. Identifier
Source Gear Factor Percentage Value
834
Offset frequency
Offset Frequency
In Parameter
to the reference frequency after consideration of the gear factors if the logic source from Parameter
Activate Frequency Offset
Parameter
No. Identifier
Offset Frequency
835
Activate Frequency Offset
836
Parameter setup
Gear Factor Numerator at Dmin
Parameters
normally set such that the winding drive will follow the process exactly at the right speed when the
coil is empty.
In the case of indirect tension control (see Chapter 4.1 "Example: Indirect traction control") is set
such that the winding drive tries to wind 5-10% too fast at all times.
If the Diameter Calculator is configured correctly, the value from actual value parameter
Linefreq. to Winderfreq. at Dmin
erably, the gear factor should be calculated manually and Parameters 832 and 833 should be set
such that maximum accuracy is reached.
Via the percentage from Parameter
adjustment of the reference frequency is reached Normally, the right setting is source Q.8942 gener-
ated by the Diameter Calculator. It will supply, at D
increasing diameters.
5.3.2

Output values

The output value can be obtained from the following source:
-1
Frequency [s ]
Output frequency of gear stage
Q.8902 –
11/13
832 and
Unit
-
-
Source Gear Factor Percentage Value
Unit
-
835, you can define a fixed frequency value. This value will be added
836 is TRUE.
Unit
Hz
-
832 and
844 can be used as a reference for the gear factor to be set. Pref-
Source Gear Factor Percentage Value
ACU
Winding Drive
T I elsto.eu
+31(0)88 7865800
Gear Factor Denominator at Dmin
Setting range
1 .. 2147483647
1 .. 2147483647
834.
Setting range
Source percentage table
Setting range
-50.00 .. 50.00
Sources logic table
Gear Factor Denominator at Dmin
834, diameter-dependent
, the value 100% and decreasing values with
min
833 define
Default settings
1
1
Default settings
8942 – Speed Factor
at Dact filtered
Default settings
0.00
7 - Off
833 are
Gear Factor
33