Parameters For Limitation Of Controller Output And Ramping; Behavior In An Emergency Stop Or Stop; Parameters For Weighting And Inversion Of The Controller Output - BONFIGLIOLI Vectron ACTIVE CUBE Applications Manual

Voorhout • Groningen • Weert • Hoogerheide
5.1.2

Parameters for limitation of controller output and ramping

The controller output is limited via Parameters
Limit Controller Output
807.
Parameter
No. Identifier
Negative Limit Controller Output
806
Positive Limit Controller Output
807
In the case of a large control deviation, Parameter
lected logic source is TRUE.
If, when the drive is switched on, the control deviation is higher than the value set via Parameter
Limit Ramp-Switch-On
813, the output of the controller will be changed at the frequency increment
Ramp Increment
set in 810 until the control deviation becomes smaller than the value in
Switch-Off
812 once.
Parameter
No. Identifier
Enable Ramping
811
Ramp Increment
810
Limit Ramp-Switch-Off
812
Limit Ramp-Switch-On
813
5.1.3

Behavior in an emergency stop or stop

In the case of an emergency stop or a normal stop, the current output frequency of the controller
(Q.8900) is reduced to zero at the emergency ramp.
5.1.4

Parameters for weighting and inversion of the controller output

Invert Controller Output
Parameter
value TRUE.
Adapt output by Diameter
Parameter
Speed Factor
842, if the selected logic source has value TRUE. Parameter
sponds to the diameter (actual value parameter
Parameter
No. Identifier
Invert Controller Output
809
Adapt Output by Diameter
815
26
T
+31(0)88 7865800
Negative Limit Controller Output
Unit Setting range
Hz -999.99 .. 0.00
Hz 0.00 .. 999.99
Enable Ramping
Unit Setting range
- Sources logic table
Hz/s 0.01 .. 999.99
% 0.00 .. 100.00
% 0.00 .. 100.00
809 inverts the controller output if the selected logic source has
815 weights the controller output with actual value parameter
Actual Value Diameter Dact
Unit Setting range
- Sources logic table
- Sources logic table
ACU
Winding Drive
I elsto.eu
Positive
806 and
Default settings
-30.00
30.00
811 activates a ramp if the se-
Limit Ramp-
Default settings
6 - On
15.00
8.00
10.00
Speed Factor
842 corre-
841).
Default settings
7 - Off
7 - Off
11/13