Advertisement
6. Select IBM Netfinity ServeRAID 4M/4L Controller (NT 4.0); then, press Enter. A
7. When prompted, press Enter to continue.
8. Use the instructions provided in the Windows NT manual to complete the normal
9. After you complete the installation, be sure to install the latest operating system
Installing or updating device drivers after installing Windows NT 4.0
To install the ServeRAID device driver after installing Windows NT 4.0:
1. Insert the IBM ServeRAID Device Drivers diskette into the diskette drive or insert
2. Click Start → Settings → Control Panel.
3. Select SCSI Adapter; then, click the Drivers tab.
4. Click Add; then, click Have Disk.
5. In the Copy manufacturer's files from field, type one of the following:
6. Click OK; then in the next dialog box, click OK again.
7. After the device driver installs, remove the diskette or the CD from the drive and
Installing device drivers for NetWare
Use the following instructions when you do one the following:
•
•
Installing device drivers while installing NetWare
Note: There is a known problem with the FAT partition table created by Caldera DR-
To install the ServeRAID device driver while installing NetWare 4.x or 5.x:
message similar to the following will appear:
Setup is loading files (IBM ServeRAID 4M/4L Controller (NT 4.0))...
installation process.
service pack.
the IBM ServeRAID Support CD into the CD-ROM drive.
Installing from diskette
Installing from CD
where a is the diskette drive letter and z is the CD-ROM drive letter.
restart the server.
Install device drivers while installing NetWare
Install or update device drivers after installing NetWare
DOS when the following are installed on any new physical drive:
•
NetWare 5.0
•
NetWare 5.1 (English only)
The physical drive does not have to be a RAID drive.
Other versions of DOS (including Windows 95) cannot read the partition table
created by DR-DOS. The operating systems fail to recognize the partition as
valid. When the ServeRAID startable (bootable) CD starts, Windows 95 fails to
start because it cannot successfully read the C drive.
The International version of NetWare 5.1 corrects this problem. To avoid this
problem, use FDISK and FORMAT to create your start (boot) drive with a dif-
ferent version of DOS (for example, PC DOS 7) before beginning the NetWare
install process.
a:\nt4_0
z:\nt4_0
Installing device drivers
7
Advertisement
