Advertisement
5. Install OS/2, but when you are prompted to insert Diskette 1, use the updated
6. Edit the CONFIG.SYS file and verify that there is only one copy of the line
Installing or updating device drivers after installing OS/2
You can use the following instructions to install the ServeRAID device driver files after
installing OS/2 Warp Server.
To install the ServeRAID files after installing OS/2:
1. After you complete the OS/2 installation, insert the IBM ServeRAID Device Driv-
2. From an OS/2 window, type:
3. Press Enter; then, type:
4. Press Enter. The OS/2 Device Driver Installation window opens and prompts you
5. Click Install.
6. Edit the CONFIG.SYS file and verify that there is only one copy of the line
BASEDEV=IPSRAID.ADD
SET COPYFROMFLOPPY=1
Copy of OS/2 Diskette 1 .
Note: (For OS/2 Warp SMP only.) After the OS/2 installation copies all the files to
the C drive, the installation prompts you to do one of the following:
•
Remove the diskette from the diskette drive and press Enter.
•
Keep the diskette in the diskette drive and press F3.
You must keep the diskette in the diskette drive and press F3 to install the
OS/2 patches. Type the following at the DOS command prompt:
a:os2ldrfx
where a is the diskette drive letter.
BASEDEV=IPSRAID.ADD.
Notes:
a.If you have more than one ServeRAID or SCSI adapter in your server, make
sure that the BASEDEV statement for the adapter or controller controlling the
startup (boot) device appears first in the CONFIG.SYS file before the
BASEDEV statements for other ServeRAID or SCSI adapters.
b.After you install any service packs, check the path for the IPSRAID.ADD device
driver and verify that the correct device driver is installed.
ers diskette.
a:
where a is the letter for the diskette drive that contains the ServeRAID diskette.
ddinstal
for the source and destination drives. The source directory shows where to insert
the IBM ServeRAID Device Drivers diskette. The destination directory shows
where the program will copy the device driver files.
•
The program copies the following ServeRAID device driver statement to your
CONFIG.SYS file: BASEDEV=IPSRAID.ADD
•
The program copies the IPSRAID.ADD ServeRAID device driver to the OS/2
subdirectory on your hard disk.
BASEDEV=IPSRAID.ADD.
Notes:
a.If you have more than one ServeRAID or SCSI adapter in your server, make
sure that the BASEDEV statement for the adapter or controller controlling the
11
Installing device drivers
Advertisement
