Advertisement
5. Remove all other non-ServeRAID IDE and SCSI disk-storage adapters or control-
6. Follow the instructions in "Installing the device drivers while installing UnixWare"
7. Turn off the server.
8. Install any non-ServeRAID disk-storage adapters or controllers in the server;
9. Install the second ServeRAID controller from the list you created in step f on page
10. Turn on the server and allow UnixWare to detect the new disk-storage adapters
11. Turn off the server.
12. Repeat step 9. through step 11 until all ServeRAID adapters, ServeRAID control-
13. You can now partition and format the logical drives attached to the additional
Installing UnixWare on a non-ServeRAID drive: Use the instructions in this sec-
tion if you are using multiple disk-storage adapters or controllers, you are installing
UnixWare on a drive attached to a non-ServeRAID adapter or controller, and you
intend to store only data on the drives attached to your ServeRAID adapters and con-
trollers.
1. Install all ServeRAID controllers that you intend to use in your server.
2. Using the ServeRAID Manager program, create all of your arrays and define all of
3. Make a list of all of the ServeRAID controllers, including the order and slot num-
18
ServeRAID™-4x Ultra160 SCSI Controller Device Driver Installation Instructions
•
If only disk drives are attached to the integrated controller, disconnect
the SCSI cable from the ServeRAID connector on the system board.
See the label inside the server cover for the location of the ServeRAID
connector.
lers.
Note: If one of the disk-storage controllers that you need to remove is on the sys-
tem board, you must do one of the following:
•
If the CD-ROM drive that you are using to install your operating sys-
tem is attached to the integrated disk-storage controller, disconnect or
remove all disk drives attached to the integrated controller.
•
If only disk drives are attached to the integrated controller, disconnect
the cable for the integrated controller from the IDE or SCSI connector
on the system board. See the label inside the server cover for the
location of the IDE or SCSI controller connector.
on page 19; then, return here and continue with step 7.
then, attach the drives to the disk-storage adapters and controllers.
17; then, attach the drives to the ServeRAID controller.
and controllers.
lers, and drives are installed.
ServeRAID adapters and controllers. See the information provided with UnixWare
for more instructions.
your logical drives.
bers, installed in the server. To do this:
a. Turn on the server.
b. When the ServeRAID Mini-Configuration prompt appears, press Ctrl+I. When
a server contains more than one ServeRAID controller, a selection screen
appears.
c. The menu lists the ServeRAID controllers in order. Select the first ServeRAID
controller from the menu.
d. Select Advanced Functions from the Main Menu.
e. Select View Controller and PCI Information from the Advanced Functions
menu.
Advertisement
