Protection For Transportation; Securing The Cr Unit - Epson L565 Service Manual

L565/L566 Series

5.3 Protection for Transportation

This section describes the cautions for packing the printer before returning it to the user.

5.3.1 Securing the CR Unit

Purpose
To prevent damaging the Change Lever by shock during transportation.
Risks if it is not performed
Fatal error caused by the damage of the Change Lever.
Preparation
Prepare a piece of strong tape
Length: 180 mm, width: 14 mm, fold one end 5 ± 2 mm.
Method
In order to prevent damaging the Change Lever, the CR Unit should be secured at the
position indicated in Step 2. Therefore, when securing the CR Unit with strong tape, hold the
Timing Belt to keep the position of the CR Unit as is and avoid the CR Unit from moving to
the 0-digit side.
1. Turn off the printer to set the CR Unit to its home position.
2. Pull the CR Timing Belt, and move the CR Unit to the 80-digit side slightly so that the CR Unit can touch
the side of the tip on the Change Lever.
3. Attach the not-folded end of strong tape on the bottom of the CR Unit.
4. Attach the strong tape on to the Housing Right, and secure the CR Unit.
Appendix
Strong tape
Housing Right
Change Lever CR Unit
Figure 5-3. Securing the CR Unit
Protection for Transportation
CR Unit
Align the bottom
of the CR Unit.
Revision A
Folded ends
81
Confidential