Epson L565 Service Manual page 74

L565/L566 Series
Top: Multifunction Printer Apply grease on ribs
Apply grease on ribs
Figure 4-9. Lubrication of the Frame Base (2)
Maintenance
<Part supply as ASP>
Supplied as the Printer
Mechanism
<Lubrication status when
supplied as ASP>
Apply grease on sides.
Lubricated
<Lubrication Point>
1. Contact points (x2) on
2. Contact points (x7: only
<Type>
1. G-71
2. G-74
<Application Amount>
Frame Base
Appropriate amount
<Remarks>
1. Application Point
2. Application Point
Bottom: Multifunction Printer
Apply grease on ribs
Apply grease on both sides of dowels
Apply grease on the groove
the Frame Base with the
Hopper
Multifunction Printer)
on the Frame Base with
the Stacker Assy
Apply with flux
dispenser.
Stir G-74 before use.
Rear left Apply grease on rib
Lubrication Points and Instructions
Apply grease on the groove
Frame Base
Figure 4-10. Lubrication of the Frame Base (3)
Rear right
Apply inside the groove Apply grease on rib
Figure 4-11. Lubrication of the Frame Base (4)
Revision A
<Part supply as ASP>
Supplied as Printer
Mechanism
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
Contact point (x3) on the
EJ Roller with the Frame
Base
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Apply grease along the
groove on the Frame
Base.
Application Point
<Part supply as ASP>
Supplied as the Printer
Apply inside the groove
Mechanism
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
Contact points (x4) on the
Frame Base with the Paper
Support Assy
<Type>
G-74
<Application Amount>
Appropriate amount
<Remarks>
Apply with flux
dispenser.
Stir G-74 before use.
Frame Base
Application Point
74
Confidential