Epson L565 Service Manual page 55

L565/L566 Series
PS Unit
Frame Base PS Unit cable
Bottom of Frame Base
Ferrite core
PS Unit cable
Pull out the PS Unit cable from the hole of the Frame Base first, and then
route it through the rib of the Frame Base.
Put the ferrite core into the position shown in the figure above.
Head FFC (Routing on the CR Unit)
Left side of CR Unit
Head FFC
CR Encoder FFC
Rib A
Connector of
CR Encoder
Connector of Printhead
Rib B
Route the CR Encoder FFC along the Rib A and connect it to the
connector of the CR Encoder.
Route the Head FFC through the rib A and B, and then connect it to the
connector of the Printhead.
Disassembly/Reassembly
PF Motor
Frame Base PF Motor cable
Bottom of Frame Base
Rib
Hole
PF Motor
Route the PF Motor cable as follows.
1. Pull out the PF Motor cable from the hole of the Frame Base.
2. Install the PF Motor, and secure the PF Motor cable (black) with the rib of
the Frame Base, and then route it through the rib of the Frame Base.
CR Unit
Aligning Head FFC with CR Encoder FFC
Head FFC
CR Encoder FFC
Rib
Hole
Route PF Motor
cable through rib.
Secure PF Motor
cable (black) with rib.
Head FFC/CR Encoder FFC
Align the Head FFC and CR Encoder FFC, and then route them through the FFC Holder as shown in the figure above.
Routing FFCs/cables
Head FFC (Routing on the Main Frame)
Fold here inside FFC Holder
Rear
Main Frame
Stack the Head FFC over the CR Encoder
FFC to keep the Head FFC on top.
FFC Holder
Revision A
FFC Holder
Head FFC/CR Encoder FFC
55
Confidential