Epson L565 Service Manual page 67

L565/L566 Series
1. Move the CR Unit to the center of the printer.
2. Place the thickness gauges (1.6 mm) on the position A shown in
80-digit side
3. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit does not touch the
thickness gauges.
4. Move the CR Unit to the center, and place the thickness gauges (1.6 mm) on the position B shown in
3-1.
5. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit does not touch the
thickness gauges.
6. Move the CR Unit to the center, and place the thickness gauges (2.0 mm) on the position A shown in
3-1.
7. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit touches the thickness
*2
gauges.
8. Move the CR Unit to the center, and place the thickness gauges (2.0 mm) on the position B shown in
3-1.
9. Pull the CR Timing Belt to move the CR Unit to both ends and confirm the CR Unit touches the thickness
*2
gauges.
Note "*1": If the CR Unit comes in contact with the thickness gauges, the PG is smaller than the standard value, therefore, check if the
unit is correctly reassembled. If not, reassemble the unit and perform PG check again. (If the unit is correctly reassembled,
replace the unit with a new/refurbished one.)
"*2": If the CR Unit does not come in contact with the thickness gauges, the PG is greater than the standard value, therefore, check
if the unit is correctly reassembled. If not, reassemble the unit and perform PG check again. (If the unit is correctly
reassembled, replace the unit with a new/refurbished one.)
Adjustment
B
A
Figure 3-1. Position of the Thickness Gauge
*1
*1
Required Adjustments
Figure 3-1.
0-digit side
Revision A
B
A
Thickness gauges
Figure
Figure
Figure
67
Confidential