Epson L565 Service Manual page 75

L565/L566 Series
Main Frame Assy
Frame Base
CR Unit
Figure 4-12. Lubrication of the Main Frame Assy
LD Roller Assy
EJ Roller Gear
Figure 4-15. Lubrication of the LD Roller Assy
Maintenance
<Part supply as ASP>
Supplied as the Printer
Main Frame Assy Mechanism
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
1. Contact point (x1) on
the upper side of the
Main Frame Assy with
the CR Unit
2. Contact points (x4) on
the lower side of the
Main Frame Assy with
the CR Unit
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Application Point
<Part supply as ASP>
Supplied as the LD Roller
Shaft
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Cam of the contact point
with the Hopper/Paper
Back Lever (x2)
<Type>
G-71
<Application Amount>
φ 1 mm x Appropriate
amount
<Remarks>
Apply with injector.
Apply before attaching
the LD Roller Assy.
After applying to the
specified position,
rotate the EJ Roller
Gear to spread the
grease.
Application Point
Hopper
Application Point
Figure 4-13. Lubrication of the Hopper
Frame Base
EJ Roller
Application Point
Figure 4-16. Lubrication of the EJ Roller
Lubrication Points and Instructions
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Contact point on the
Hopper with the Frame
Base
CR Driven Pulley Holder
<Type>
G-74
<Application Amount>
Appropriate amount
<Remarks>
Apply with flux
dispenser.
Stir G-74 before use.
1. Application Point
2. Application Point
Figure 4-14. Lubrication of the CR Driven Pulley Assy
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
EJ Roller Gear
Contact point (x1 on the
shaft) on the EJ Roller with
the Frame Base
<Type>
G-71
<Application Amount>
0.06 g
<Remarks>
Apply with injector.
Lubricate before
attaching the part.
Application Point
Figure 4-17. Lubrication of the EJ Roller Gear
Revision A
<Part supply as ASP>
None
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. On the bearings (x2) of the
CR Driven Pulley on the
CR Driven Pulley Holder
2. Contact points (x6) on
the groove of the CR
Driven Pulley Holder
with the Main Frame
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Check the lubrication
condition and apply
grease if necessary.
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Shaft on the EJ Roller
Gear
<Type>
G-71
<Application Amount>
φ 1 mm x 1 circle
<Remarks>
Using injector, apply
grease along the tier on
the shaft.
Lubricate before
attaching the part.
75
Confidential