Bosch AutoCook MUC6 Series Instruction Manual page 24

en Customised setting options
4. Press button G to start with the
selected settings.
The appliance heats up the pan until the
target temperature or the steam pressure is
reached.
Once the target temperature or steam
pressure is reached, the lines go out and
the next preparation time is shown in the
display. The preparation process starts
automatically.
recipe 1 / recipe 2 –
saving personal preparation
programmes
Personal preparation programmes with
customised time / temperature and steam
pressure function can be saved under the
memory locations [ recipe 1 ] and [ recipe 2 ].
Notes:
■ If you have not previously saved any
personal preparation programmes, the
display does not show any values.
■ In order to switch on the steam pressure
function, the pressure locking handle
must be closed (N).
1. In function selection mode, press
button D once.
The LED [ recipe 1 ] lights up. The pre-
configured preparation time is shown in the
display.
Saving the preparation time:
2. Press button F once.
The display flashes. LED 1 (preparation
step 1) lights up in the control panel.
3. Keep pressing button F until the desired
preparation time is displayed.
When button F is briefly pressed, the
preparation time is increased by 1 minute.
When button F is pressed for a longer
period, the preparation time is increased
by 10 minutes. The time increases up to
the pre-configured maximum value and
then returns to the pre-configured minimum
value.
24
Saving the preparation temperature or
steam pressure:
4. Preparation temperature: Press
button C once. The pre-configured
preparation temperature is shown in the
display. Press button C repeatedly until
the desired preparation temperature is
displayed.
or
Steam pressure: Press button L to
switch between [ K ] and [ L ].
5. Press and hold button G (>2 seconds)
to save the set values.
Note: Either the temperature or the steam
pressure can be set and stored for one
preparation step. The value last selected
is saved.
In order to programme other preparation
steps, repeat points 2 to 6. Up to 3
preparation steps can be programmed.
The saved preparation programme
[ recipe 1 ] can be selected as usual via
function selection mode.
Note: To save a second personal
preparation programme under [ recipe 2 ],
use the same process as described above
for [ recipe 1 ].
To delete a personal preparation
programme, perform the following steps:
1. In function selection mode, press
button D once.
The LED [ recipe 1 ] lights up. The saved
preparation time is shown in the display.
2. Press button F once.
The display flashes. LED 1 (preparation
step 1) lights up in the control panel.
3. Press and hold button H (>2 seconds).
The settings for [ recipe 1 ] are deleted.
Note: To delete the second personal
preparation programme [ recipe 2 ], use
the same process as described above for
[ recipe 1 ].