Bosch AutoCook MUC6 Series Instruction Manual page 20

en Additional functions
1. Keep pressing button E until the
desired indicator is lit. The display
changes from [ medium ] to [ long ] and
then to [ short ] before returning to
[ medium ].
The corresponding pre-configured values
for the preparation time are shown in the
display.
2. Press button G to start the preparation
programme.
Setting a start time delay
The start time delay can be set for the
selected preparation programme so you
can enjoy a freshly prepared meal at a
specific time.
Note: The start time delay can only be
set for certain preparation programmes.
The pre-configured start time delay varies
among these preparation programmes.
1. Select the preparation programme.
2. Press button A. Button G flashes.
"00:10" flashes in the display.
Press button A repeatedly to increase the
displayed time. A brief press increases the
time by 5 minutes. A slightly longer press
increases the time by 10 minutes. Pressing
and holding button A for around 2 seconds
increases the time by 30 minutes.
3. Press button G when the desired start
time delay is displayed.
The desired start time delay is shown in the
display. [ timer ] lights up in the display.
The time until the start counts down. Once
this time has elapsed, the preparation
process starts automatically.
Notes:
■ The start time delay can be switched
off at any time by pressing button G.
The preparation programme then starts
immediately.
■ If "00:10" does not flash in the display,
a start time delay cannot be set for the
selected preparation programme.
20
Multiple preparation steps
Certain preparation programmes can consist
of several preparation steps. An audible
signal sounds once the next step is required.
In the control panel, LEDs 1, 2, 3 or 4 are
shown accordingly and button G flashes.
■ Open the lid of the appliance.
■ Add additional ingredients.
■ Depending on the recipe, refer to the
preparation method (e.g. with or without
steam pressure function, open lid).
X See recipe book provided
■ Start the next preparation step using
button G.
The appliance heats up the appliance interior
until the target temperature or the selected
steam pressure of the next preparation step
is reached. During the heating phase, lines
that light up in a clockwise direction appear
in the display. Once the target temperature
or selected steam pressure is reached, the
lines go out and the next preparation time
is shown in the display. The preparation
process starts automatically. The preparation
time counts down.
Prematurely terminating the
current preparation step
If the ingredients are cooked ahead of time
during one of the preparation steps, the
step can also be terminated manually.
1. To do this, press button G for at least
2 seconds.
This will terminate the current preparation
step. An audible signal will then sound as
usual once the next step can be carried out.
In the control panel, LEDs 1, 2, 3 or 4 are
shown accordingly and button G flashes.
2. Perform the next preparation step.
Keep warm function
Certain preparation programmes include the
keep warm function. X "List of preparation
programmes" see page 26