Mono; Status; Firmware Updates - Classe Audio Delta PRE Owner's Manual

Mono

Status

Firmware Updates

specific sources, they may also be called from the Main Menu page or the remote
control. Pressing the Configurations button in the Main Menu or choosing
CONFIG SELECT on the remote opens the Configurations page. Choose the
configuration you wish to employ.
To customize configurations, see the Configuration Setup description in the
System Setup section.
Pressing the Mono button combines L & R channels, resulting in monaural
output on all channels (including Auxiliary and subwoofer channels). When in
Mono, the Mono button is shaded. Press again to deselect and return to normal
stereo operation. When in Mono, the word Mono appears on the Home page.
The Status screen provides several items of information on the currently selected
source and configuration as well as access to information on the firmware used
in and the internal settings and sensors of the Delta PRE. While on this page,
pressing the more button will access the CAN-Bus features for connected Classé
components.
Please visit http://classeaudio.com to download the latest firmware and related
documentation for your unit. There are two approaches to updating the
firmware for the Delta PRE.
One way is through the front panel USB connector, which can be used to load
firmware updates. The firmware would be loaded onto a USB stick. With
the rear panel power switched off, plug the USB stick into the front panel of
the Delta PRE. When the power is switched back on from the rear panel, the
update will proceed automatically. The LED indicator will commence with
a series of flashing red, off and blue. After several seconds, it will flash blue
continously for up to several minutes, depending on the size of the update.
The touchscreen may flash white as well. At the end of the update you will see
the touchscreen turn white with a small target awaiting your input for screen
calibration. Using your finger or something smaller like a pencil eraser, touch
the screen in each of the successively identified areas to calibrate it. Once
complete, the light on the USB stick will extinguish and the touchscreen will
show the Home page. Remove the USB stick and continue using the Delta PRE.
Remember that any subsequent setup changes are stored when the Delta PRE is
put into standby.
As an alternative to the standard USB stick method of updating the unit's
firmware, updates may be initiated from the Delta PRE web interface page.
Using the Firmware tab on the Delta PRE's web page, confirm that the firmware
version currently installed is not the latest and click on the System restart
button. Follow the prompts to complete the update.
33