Other Status; Name; Event Log; Network Sources - Classe Audio Delta PRE Owner's Manual

Other status The Other Status screen displays information about the target unit's internal

Network Sources

36
a particular unit to be excluded from Global Dim, deselect Global Dim for that
unit.
temperature sensors. Readings for Heatsink 1 & 2 are displayed in degrees
Celsius.
Note: This feature is only available when the target amplifier is in operate mode.
name You can set the name which will appear next to the unit model name and
facilitate the identification of units in large systems.
Event Log Reserved for amplifiers, this feature records protection circuit events and can
only be accessed when the target amplifier is in standby.
Note: For the amp to be put into standby while allowing the unit with the
touchscreen to remain in operate mode, Global Standby for the amp must be de-
selected (not highlighted) so the amp can be manually put into standby.
The protection circuit shuts down the amplifier or channel if it overheats or if
its output could damage your speakers. The Event Log details the circumstances
surrounding the amp going into protection and should be referred to in
situations that require the intervention of your dealer or Classé customer
support.
The Delta MONO Event Log can report the following events interpreted as
follows:
• DC Output — DC from the source has exceeded the amplifier's ability to
correct for it. The amplifier will shut down to protect the loudspeaker.
• Over Current — The peak current has exceeded the safe operating limit,
i.e. a short circuit.
• CBE — Comm Board Error. There has been an internal communication
error.
• Over Temp — The internal temperature has exceeded the safe operating
limit.
• Fan Failure — The fan has been disconnected or is unable to spin.
Protection events are rare and generally occur due to issues that are external
to the amp. They should be interpreted positively. The amp is doing what it's
designed to do.
Network sources are those which stream audio to the Delta PRE using its rear
panel Ethernet connection. The Delta PRE is equipped with a hard-wired
Ethernet connection because it provides a more reliable and higher speed
connection than is typically available over WiFi. If it is not possible or practical
to run a direct Ethernet connection from your router to the Delta PRE, various
solutions are available. A powerline Ethernet adaptor, such as those offered by
Netgear and others may be used or a wireless bridge such as Apple's Airport
Express provides the local Ethernet cable (called LAN or Local Area Network)
connection required by the Delta PRE and connects to the Network router via
WiFi.