Wacker Neuson M 1000 Operator's Manual page 8

Safety Information
2.2.8
2.2.9
2.2.10 Keep handle, and other areas where motor and shaft are gripped, dry,
2.2.11 Avoid unintentional starting! Don't carry motor around jobsite while it
2.2.12 NEVER operate machine when you are tired. Remain alert, watch
2.2.13 NEVER operate machine if switch does not function properly. Have
2.2.14 ALWAYS replace worn or damaged components with spare parts
2.2.15 DO NOT overload motor. An overloaded motor will overheat. Use only
2.2.16 DO NOT allow untrained personnel to service this equipment. Only
2.2.17 NEVER attach shaft to motor while it is running.
2.2.18 ALWAYS check the power supply before running motor. Using the
2.2.19 ALWAYS make sure motor switch is OFF before plugging motor to
wc_si000104gb.fm
Goggles or safety glasses will protect against eye damage caused by
flying debris.
NEVER carry motor by cord or pull on it to disconnect it from
receptacle. Keep cord away from heat, oil and sharp edges.
clean and free from oil and grease.
is connected to power source. Don't carry motor with finger on switch.
what you are doing and use common sense.
defective switches replaced by authorized service center.
designed and recommended by Wacker.
recommended head/motor/shaft combinations. See Table 1.
trained electrical technicians should be allowed to service the electrical
components of this equipment.
wrong voltage supply will damage motor.
power supply.
6
HMS