Assembling The Ignition Module - Husqvarna 356BTx Workshop Manual

7.5.2 Assembling the ignition module

1. Place the nut holder on the ignition module.
2. Twist the hub to the correct position so that the
ignition module is correctly positioned next to the
hub magnet. The air column between the ignition
module and the hub should be 0.2 mm . Place
airgap tool 544 01 68-01 between the hub and the
ignition module.
544 01 68-01
Note: Make sure the contact plate remains on the
right-hand screw that holds the ignition module.
3. Fasten the two screws.
4. Mount the short-circuit cables.
IMPORTANT!
Make sure the ignition cable sits firmly in
the clip. The cable can get caught in the fan
5. Push down the sparkplug cap and seat the ignition
cable in the clip.
7 Repairs
8015-012
8015-013
8015-011
25