Assembling The Flywheel And Ignition Module - Husqvarna 525BX Workshop Manual

Repair instructions
7.19 Assembling the flywheel and
ignition module
1
When setting the key on the crankshaft, make
sure the end face of the key is parallel with the
crankshaft.
Fix the piston in place with the stopper (special
tool) and tighten the rotor nut.
Torque 10~15 Nm
Fig 10
Flywheel
A
Flywheel nut
B
2
Install the springs and ratchets to the flywheel and
tighten screws(C) Torque : 3-4Nm
Check that the cable (D) is connected correctly
to the ignition module. Protective cable must be
clamped to the grooves (E) of the insulator and the
muffler plate (F).
Place the ignition module in position and fit the
screws. Do not tighten the screws.
Make sure the gap is: 0,3 mm
Tighten the bolts while pressing the ignition module
to the flywheel.
Torque : 2.5-3.5Nm
Assembly the spark plug and all covers.
NOTE!
Check the spacer any crack and deforma-
tion and replace if needed. Also replace
the screws.(loctite).
To assemble ignition module, see 7.6
46
- English
D
E
C
B
A
F