7.1 General repair instructions
WARNING!
The battery must always be removed
for service/repair work and may only
be replaced once the machine has
been completely assembled again!
7.2 Dismantling the throttle
Lift the throttle control out of the chassis.
See figure 1.
Cleaning and inspection
Clean and check all parts thoroughly. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
See figure 2
7.3 Assembling the throttle
Press in the pin (A) on the main switch a few mm
to facilitate assembling the throttle control in its
fastening on the chassis.
Make sure the rear "lip" (B) on the throttle control
enters into the chassis.
See figure 3
7 Repair instructions
NOTE!
Note how wires, components, etc., are
positioned before dismantling. Make sure
to position them correctly to avoid pinching
when the machine is reassembled.
Fig 1
Fig 2
Fig 3
Repair instructions
A
B
21
English –