Outline Of Setting - SMC Networks PF2W7 Series Operation Manual

Outline of setting

The output will not operate for 3 seconds after supplying power.
The mode in which the flow is detected and displayed, and the switch function is operating.
This is the basic operating mode; and other modes should be selected for setting
changes and other function settings.
The display of instantaneous flow and accumulated flow can be changed
while the button is pressed.
While pressing the
the accumulation can be started/stopped by pressing the
button
press
for 2 sec.
Initialize mode
(Refer to page 22)
Items below can be set.
Display mode
Unit selection function
Output mode (OUT1)
Output mode (OUT2)
Switch operation (OUT1)
Switch operation (OUT2)
: Operate only the product with unit selection function.
Power is supplied
The identification code of the product is displayed.
Measurement mode
button during the display of accumulated flow,
Function selection
mode
(Refer to page 26)
Items below can be set.

[F_1]
Input the Set value of
instantaneous output
[F_2]
Input the Set value of
instantaneous output
(Auto-preset)
[F_3]
Input the Set value of
accumulated output
button.
button
press.
This function is used to
prevent errors occurring
due to unintentional
changes of the Set
values.
-20-
button
press
for 3 sec.
Key-lock function
(Refer to page 31)
No.PF※※-OMO0012-D