Component Maintenance Manual; Model Fa5000 - L3 FA5000 Component Maintenance Manual With Illustrated Parts List

5. COMPONENT MAINTENANCE MANUAL (CMM) DESCRIPTION
This CMM consists of a single volume. The manual conforms to the intent and form of Air
Transport Association of America (ATA) Specification 100. The manual is written for an
audience of operators and both intermediate− and depot−Level maintenance technicians.
Functional, electrical and mechanical aspects of the Model FA5000 are documented; that
is, description, specifications, operation, testing, removal and replacement, etc. are con-
tained in this manual. The CMM content is summarized as follows:
A. FRONT MATTER
Front Matter material consists of a title page, service bulletin list, record of revisions,
record of changes, list of effective pages, table of contents, and this introduction.
B. DESCRIPTION AND OPERATION
This section contains the description and operation information for the Model
FA5000 Cockpit Voice Data Recorder. Line art is used to illustrate the unit, its inter-
connections and functionality. This section also contains the Model FA5000 Theory
of Operation.
C. TESTING AND TROUBLESHOOTING
Sections 100 contains specific checks and tests required to determine the operation-
al condition of a unit that has been removed from service. Also included in the sec-
tion are tables of required test equipment, test set-up data, procedures, and test pa-
rameters. Troubleshooting data is presented in a tabular form with each entry re-
lated to a specific test and fault isolation task. Fault isolation is provided to a Level-2
maintenance, or circuit board removal and replacement level.
No calibration of circuit boards within the Model FA5000 is required. The Model
FA5000 Solid-State Cockpit Voice Data Recorder is considered an "ON CONDITION
LRU".
D. DISASSEMBLY
This section provides all the information required to completely disassemble the
FA5000 to its Lowest Replaceable Unit (LRU) defined by the maintenance philoso-
phy as the circuit board assemblies. The steps of each procedure are coordinated
with the TESTING AND TROUBLESHOOTING Section. Access to subassemblies
within the FA5000 is described such that there is minimal disturbance to other sub-
assemblies.
Each major disassembly task is accompanied with a line art exploded-view of the
subassembly area which is cross referenced to the applicable Illustrated Parts List
(IPL) drawing for ordering replacement parts.
Use or disclosure of information on this sheet is subject to
the restrictions on the cover page of this document.
The document reference is online, please check the correspondence between the online documentation and the printed version.
AVIATION RECORDERS

COMPONENT MAINTENANCE MANUAL

Model FA5000

23−70–40
Introduction
Initial Issue Page 4
Sep. 30/11