Advertisement
Removing the Chassis Cover
Make sure the system and all other peripheral devices connected to it have been powered-off.
1.
Disconnect all power cords and cables.
2.
The 8 mounting screws on the rear side of the system are used to secure the cover to the
chassis. Remove these screws and put them in a safe place for later use.
Mounting screw
Mounting screw
Installing a SATA Drive
The system can accommodate one 2.5" SATA drive.
1.
Align the mounting holes of the SATA HDD with the mounting holes on the HDD drive bay
and use the provided mounting screws to attach the SATA HDD to the drive bay.
Mounting screw
2.
Connect the SATA cable. Align the mounting holes of the HDD drive bay with the mounting holes
on the system and use the provided mounting screws to secure the drive bay in place.
Quick Installation Guide |
Mounting screw
2
Advertisement
