Table of Contents
Advertisement
8
Important Information
8.1.4
Filling Slimsorba Carbon Container
For the first startup, perform the following steps in the order given to fill the carbon container with
activated carbon:
1.
Loosen the upper pipe flange on the carbon container.
2.
Loosen the quick release fastener on the cover and lift off the cover
3.
Remove fine filter sieve and clamping ring.
4.
Fill in 12 kg/26.5 lb of activated carbon (cylindrical pellets with approx. 4 mm/0.16 inch
diameter, type SUPERSORBON K40). The heating coil must be covered.
5.
Replace the fine filter sieve and clamping ring.
6.
Replace the cover and close the quick release fasteners.
7.
Secure the upper tube of the carbon container again.
The Slimsorba is an integrated multiple-cycle unit for reducing the solvent residue in perc machines.
The Slimsorba is desorbed with hot air.
As an integrated multiple-cycle, no extra space is required for the Slimsorba, unless you are using a
multiple installation (see Point 5.2.1).
The main components of the Slimsorba are:
Carbon container with carbon filling for adsorption
-
(activated carbon must be filled in when the machine is commissioned) and auxiliary heating
battery to support the desorption
-
Heater battery for hot air desorption
-
Fan for moving the air flow
-
Sensors for temperature monitoring
Connecting pipes to the drycleaning machine
-
8.2 Refrigeration Unit
Attention:
No cooling agent is allowed to escape into the atmosphere during
operation, servicing work and decommissioning of refrigeration units.
You must keep a record of the quantities of cooling agent used and
present this record to the authorities upon demand.
Only people who have the necessary special knowledge and technical
equipment are authorized to service and decommission refrigeration
units.
34
8
8.2
P25/P30
Advertisement
Table of Contents
