Installation; Mechanical Connection; Load Hook And Chains; Adjustmentsadjustments - probst SRG Series Operating Instructions Manual

Operating Instructions
SRG-1,5/SRG-3/SRG-3-L

4 Installation

4.1

Mechanical connection

4.2

Load hook and chains

●
Fit suspension ring in the load hook of the lifting equipment/carrier.
●
Ensure that the single chains are not twisted and may be easily pulled through the jaws
●
Attaching the device to the lifting equipment take care that all local safety regulation is observed.
●
It is not allowed to exceed the carrying capacity of the lifting equipment with the device and the maximum
load.

5 AdjustmentsAdjustments

5.1.1

Adjustment to suit the Pipe Outside Diameter

●
When leaving the factory the chains are adjusted to the maximum length.
If the chains are too long (in case of a lower construction height) release
bolts .
●
Adjust all chains to the same length and secure chains . The inclination
angle must not exceed 45° : Danger of releasing the load !
10 /17
Installation
Fig. 1
V3
Fig. 2
GB