Table of Contents
Advertisement
2.2 Configuring the Windows Ethernet Interface
This topic applies only to the Microbox 427B-RTX/ -HMI/RTX and Panel PC 477B-HMI/RTX
and is not applicable for the Panel PC 477B-HMI. The physical locations of the Ethernet
connections differ between the Microbox 427B and Panel PC 477B. Pre-configuration of the
Ethernet connections, however, is identical for both PCs.
Microbox 427B
The Microbox 427B has two built-in Industrial Ethernet interfaces. The pre-configuration
(Page 12) specifies that the rightmost Ethernet connection "Ethernet 2" is associated with
the IE_General of the PC Station in index 3 and is pre-configured for Industrial Ethernet
communication. You must configure the IP address of the Industrial Ethernet interface in
Windows XPe as configured in the STEP 7 project.
Figure 2-3
Microbox 427B-RTX/ -HMI/RTX and Panel PC 477B-HMI/ -HMI/RTX
Manual, 12/2007, A5E01217837-01
Microbox 427B Ethernet connection
2.2 Configuring the Windows Ethernet Interface
User Tasks
37
Advertisement
Table of Contents
