Table of Contents
Advertisement
Station Configuration
Microbox 427B-HMI/RTX, Panel PC 477B-HMI,
and Panel PC 477B-HMI/RTX includes an initial
configuration for all components. No configuration
in the Station Configuration Editor is necessary,
unless you have a requirement to change the
configuration or use other SIMATIC software
components. See the topic " Downloading PC
Station Components " for more information.
The tasks described in the
Communication 2007, Part 1 and Part 2 User's
Manuals
HMI/RTX and Panel PC 477B-HMI/ -HMI/RTX.
Main Memory Handling
WinCC flexible RT requires a D:\ drive on the
CompactFlash card with the EWF disabled. This
requirement is necessary because WinCC flexible
RT uses a Datafile on the D:\ drive to store
registry-inputs and systemvariables.
See also
Pre-configured SIMATIC Microbox 427B-HMI/RTX (Page 12)
Pre-configured SIMATIC Panel PC 477B-HMI (Page 24)
Pre-configured SIMATIC Panel PC 477B-HMI/RTX (Page 20)
Downloading PC Station components (Page 51)
Microbox 427B-RTX/ -HMI/RTX and Panel PC 477B-HMI/ -HMI/RTX
Manual, 12/2007, A5E01217837-01
WinCC flexible
are not necessary for Microbox 427B-
1.7 Additional information about WinCC flexible RT
WinCC flexible RT will not be inserted
automatically into the Station Configuration
Editor. A Station Configuration Editor is not
necessary for WinCC flexible RT.
WinCC flexible Communication 2007, Part 1
The
and Part 2 User's Manuals
configuration process.
A PC with a hard drive disk as main memory
does not require this configuration.
Product Overview
describe this
29
Advertisement
Table of Contents
