Removal Of Blades With Bearings - Husqvarna Rider 850 Workshop Manual

Reparation instructions

Removal of blades with bearings

1
!
WARNING!
When working with the mowing
deck, use protective glasses and
gloves.
• Release the spring which tensions the V-belt and
twist off the belt.
• Unscrew the screw which holds the pulley (2)
and detach the pulley, a puller may be needed
for this. Do not lose the key which is found
between the pulley and the axle.
2
Unscrew the screw which holds the blade and
remove the screw, washer and blade.
40
– English
2
1
3
Unscrew the four screws which hold the blade
bearing and remove the entire bearing packet from
the mowing deck.
4
Remove the hub using a puller. Do not lose the key
which is found between the pulley and the axle.
5
Remove the sheet metal safety washer.