3
Insert a garage jack under the hydrostatic transmis-
sion and loosen its five holder screws.
4
• Lower the garage jack and pull out the
hydrostatic transmission.
• Installation of the hydrostatic transmission is
carried out in the reverse hydrostatic
transmission removing order
• After installation, check that the brake wire and
throttle control are correctly adjusted (see pp.
20–22). Also check the oil level in the hydrostatic
transmission and refill as is necessary.
Removing/installation of hydrostatic
transmission Rider 1030, Rider 1200
1
• Block-up the machine in front of the rear frame
and remove the back wheels.
• Remove the transmission cover.
2
1
2
• Release the tensioning wheel spring (1).
• Remove the circlip (2), lift away the washer and
fan from the ingoing axle.
Reparation instructions
27
English –