Husqvarna Rider 850 Workshop Manual page 29

Reparation instructions
3
3
4
• Detach the drive belt (1) and release the brake
wire spring (2).
• Disconnect the brake wire (3) and dismantle the
throttle control (4).
• Remove the spring (5) and the disengaged
clutch control (6).
4
1
Disconnect the contact (1) and take off the hose
(2). Ensure that the oil does not run out, e.g. tie up
the hose higher than the oil level in the container.
28
– English
1
2
2
5
Insert a garage jack under the hydrostatic
transmission and loosen its five holder screws.
6
• Lower the garage jack and pull out the
hydrostatic transmission.
• Installation of the hydrostatic transmission is
carried out in the reverse hydrostatic
transmission removing order
• After installation, check that the brake wire and
throttle control are correctly adjusted (see pp.
20–22). Also check the oil level in the container
and refill as is necessary.