Husqvarna LC48 Workshop Manual page 24

3
22
Controls
Starter contact
Model LC48 E, LC53 E
Remove the cover over the battery and
separate the contacts.
Remove the protective cover over the
starter contact.
502 51 67-01
Disconnect the cables from the micro
breaker.
Push the locking needles to one side and
remove the breaker.
Remove the screws and remove the con-
tact holder.
Starter contact
Model LC48 E, LC53 E
Remove the protective cover over the
battery in the back edge of the mower.
Cut the contact (A) to prevent short-
circuiting.
Remove the 4 screws holding the protec-
tive cover over the starter contact.
Lift off the cover.
Pull out the cables (B blue and C brown)
from the micro breaker (D).
Push the locking needles (E) to one side
and remove the breaker.
Remove the screws (F) and remove the
contact holder (G).
Replace defective parts and assemble
in the reverse order as set out for dis-
mantling.