Repair instructions LC 141C
5. Attach the washer and tighten the blade screw with a
torque of 20 Nm.
6. Pull the blade around by hand and make sure that it
rotates freely.
7. Do a function test of the product.
5.4 To replace the motor
WARNING: Before you start, disconnect the
power cord from the product.
1. Put the product down on its side.
2. Remove the blade screw, the washers and the
blade.
3. Remove the outer motor cover, see "5.2 To remove
and attach the outer motor cover".
4. Remove the 4 nuts that hold the inner motor cover
and lift it off.
22 – English
5. Remove the 6 screws that hold the motor.
6. Put the product back in upright position.
7. Remove the 2 screws from the cable entry, remove
the bracket and lift the cable out.
8. Remove the 2 terminal screws that hold the cables to
the motor.