4.2 To replace the blade
WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
WARNING: The blade is sharp and can
cause cuts. Put on protective gloves.
1. Remove the blade screw and the washers.
2. Remove the blade. Make sure that the blade bracket
and the blade screw are free of damage, and that the
motor shaft is not bent.
3. Attach the new blade with the angled ends in the
direction of the cover.
4. Make sure that the blade aligns with the center of the
shaft.
Repair instructions LC 141VLi/LC 141Li
5. Attach the washers and the blade screw and tighten
with a torque of 20 Nm.
6. Pull the blade around by hand and make sure that it
rotates freely.
7. Do a function test of the product.
4.3 To remove and attach the motor
cover
WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
1. Put the product down on its side.
2. Remove the blade, see "4.2 To replace the blade".
3. For LC 141VLI, remove the 3 screws that hold the
transmission cover and lift it off.
English – 13