7.9.7 To assemble the ignition system
1. Attach the flywheel. Make sure that the key is in the
correct position when you install the flywheel.
2. Attach the sleeves (A) and ignition module (B) to the
cylinder.
1239 - 001 -
A
B
3. Connect the cables (C) and (D) to the ignition
module.
4. Use a feeler gauge to make sure that the distance
between the ignition module and the flywheel is 0.3
mm. Tighten the screws.
5. Put some grease on the clutch screw, but not on the
thread.
6. Attach the remaining parts in the opposite sequence
to how they were removed.
C
D
Repair instructions- 45