Table of Contents
Advertisement
6 USER GUIDE
6.3 System Definition Information
Set the items ② and ③ below for SV.LINK (LQE521). Ensure that the item ② setting is
not identical to that for MELSEC. As regards item ③, however, select the same setting for the
S10mini or S10V and MELSEC.
① Physical address
② IP address
③ Subnetwork mask
④ Route information
communications via router link.
No dedicated setup tool is provided for SV.LINK. For IP address and subnet
mask settings, use the ET.NET system tool.
6.3.1 Physical address
A 48-bit physical address is assigned to each SV.LINK. This is a unique address which is set on
the ROM; the user cannot change it. An example of a physical address (in hexadecimal) is
shown below.
Example: 00008700B001
6.3.2 IP address
The IP address used for TCP/IP and UDP/IP is a 32-bit logical address. An IP address consists
of a network number and a host number. There are three types of address assignment depending
on the number of hosts.
Class A (The high-order one bit of the network number is set to 0.)
Class B (The high-order two bits of the network number are set to 10 in binary.)
Class C (The high-order three bits of the network number are set to 110 in binary.)
An original number is set for each SV.LINK ROM.
Define these items for each SV.LINK by using the ET.NET system tool
This item cannot be set because SV.LINK does not support
Network number
(8 bit)
Network number
(16 bit)
Network number
(24 bit)
NOTICE
Host number (24 bits)
Host number (16 bits)
Host number (8 bits)
6-10
Advertisement
Table of Contents
