Ip Address Setting - Hitachi SV.LINK User Manual

4.4.3 IP address setting

Function: Set an IP address and other information for the SV.LINK module.
Operation: The procedure used is shown below.
(1) Click the Set IP Address
(2) The [Set IP Address] window will then appear. Set the desired IP address and other
information.
• Module
Select the SV.LINK module you want to set up. Since the device uses the ET.NET
system, it will display "ET.NET" instead of "SV.LINK." If so, take "ET.NET" as
"SV.LINK."
• IP Address/Subnetmask
Set an IP address, and subnet mask for the SV.LINK module. For details, see "6.3
System Definition Information."
• Physical Address
The 48-bit address to which the SV.LINK module is assigned is displayed in this box. If
no SV.LINK module is installed for this physical address, either of the values
"00:00:00:00:00:00" and "FF:FF:FF:FF:FF:FF" is displayed instead.
button in the [Setup by module] window.
Possible choice
ET.NET (Main)
ET.NET (Sub)
4-13
Remarks
Default
4 OPERATION