4 OPERATION
4.4.2 Setup by module
Function: Display the requested window.
Operation: The procedure used is shown below.
(1) Click the [RS-232C] or [Ethernet] radio button in the [[S10V] ET.NET] window and click
the
OK
button.
(2) The [Setup by module] window will then appear.
(3) If you want to set IP address and other information for the SV.LINK module, click the
Set IP Address
(4) If you want to exit the [Setup by module] window, click the
SV.LINK is not supporting the following commands. Therefore, the following
commands cannot be executed.
Ladder and HI-FLOW (Display Communication of Error Log)
Socket handler (Display Communication of Error Log)
Display Status of DHP
Display Status of Network
button.
NOTICE
4-12
Close
button.