Table of Contents
Advertisement
(continued from the previous page):
S012
* In the above program example, the FL000, FL002, FW100, and FW101 registers are used.
When applying the program to actual plant equipment, change the registers as needed to use
registers that are not used by the other circuits.
After necessary communication parameters are set in the BD register, be sure to
start communication by writing a value other than 0 to the setting start flag. If
communication is started with undefined parameter values, a parameter error or
abnormal operation results.
DST H8F3B02 = FL000
Ｆ
DST 50 = FW100
Ｆ
MDI FW100 : 1 = FL000
Ｆ
DST H8F3B00 = FL002
Ｆ
DST 1 = FW101
Ｆ
MDI FW101 : 1 = FL002
Ｆ
NOTICE
5-15
5 PROGRAMMING
: Sets the delay time setup
area address.
: Selects a delay time
setting of 50 ms.
: Performs setup within the
module.
: Sets the start flag area
address.
: Selects a start flag setting.
: Starts the communication.
Advertisement
Table of Contents
