Table of Contents
Advertisement
(chapter 5, page 5-15)
After necessary communication parameters are set in the BD register, be sure to
start communication by writing a value other than 0 to the setting start flag. If
communication is started with undefined parameter values, a parameter error or
abnormal operation results.
(chapter 5, page 5-17)
After setting the required communication parameters in the DB register, be sure
to write a value other than 0 into the setting start flag and start communication.
If the communication is started when the parameters are unstable, a parameter
error or operation error may occur.
(chapter 6, page 6-2)
Connect a repeater to a coaxial cable via a transceiver cable and a
transceiver.
A repeater can be attached to a transceiver at any position in the coaxial
segment.
Do not attach a station to a link cable.
The distance between attached transceivers shall be a multiple of 2.5 (m).
(chapter 6, page 6-3)
The number of repeaters between the S10mini or S10V and MELSEC shall be
two(2) or less.
The number of segments to which two or more repeaters can be connected
shall be one(1).
NOTICE
NOTICE
NOTICE
NOTICE
S-14
Advertisement
Table of Contents
