Table of Contents
Advertisement
2
Product Overview
2.4.4
Slot [EXT]
The slot (
Fig. 2.2 4) enables the CMMS-AS-...-G2 to be expanded by the following optional inter-
faces:
– CAMC-PB: Interface for PROFIBUS DP
– CAMC-DN: Interface for DeviceNet.
For installation, please observe the assembly instructions for the CAMC interface. If the
interface is installed, it is automatically activated the next time the motor controller is
switched on. Information regarding functionality can be found in the respective fieldbus
manual
– PROFIBUS P.BE-CMM-FHPP-PB-SW-...
– DeviceNet P.BE-CMMS-FHPP-DN-SW-...
2.4.5
Card slot [M1] for SD memory card
A parameter set can be loaded from/saved onto the memory card by using the FCT
software. Additional information can be found in the help section for the FCT plug-in
CMMS-AS and in the description GDCP-CMMS-AS-G2-FW-...
SD memory card
Functions
Design on the device
Supported card types
Supported file systems
Format filename
1) Recommended are industry-suitable memory cards from the Festo accessories programme.
Tab. 2.7 Characteristics of the memory card (
Festo – GDCP-CMMS-AS-G2-HW-EN – 1310NH – English
Description
Copying/loading a parameter set from the memory card to the
CMMS-AS-...-G2.
Copying/saving a parameter set from the CMMS-AS-...-G2 to the
memory card.
Copying (loading) firmware from the memory card to the
CMMS-AS-...-G2 (Bootloader)
1x12-pin SD card slot
1)
SD
(version 1 and 2)
FAT16
8.3
Fig. 2.2 5 )
17
Hide quick links:
Advertisement
Table of Contents
