Subscribe to Our Youtube Channel
Related Manuals for Ayra Flash 150
Summary of Contents for Ayra Flash 150
- Page 1 Flash 150 Analog 150W strobe light User manual Any information and illustrations shown in this user manual are subject to change without further notice. User manual version: 1.0 Creation date + author initials: 03-11-2015 RV Revision date + author initials: -...
- Page 2 If you encounter any problems during use, contact your local dealer for more information and help. The Flash 150 is a powerful strobe light effect, designed as a party light and is mostly installed in party rooms, community centres, bars, dancing schools, roller-skating rinks, bowling venues etc.
-
Page 3: Safety Instructions
Safety instructions WARNING! Always keep this device away from moisture and rain! Hazardous electric shocks may occur! WARNING! Only connect this device to a matching power outlet. This device is intended to work on a specified AC current. Connecting this device to power outlets with other voltages may result in permanent damage and possibly hazardous situations, such as fire or electric shocks! WARNING! Be careful with every operation of this device. - Page 4 - Familiarise yourself with the functions of the device before use. Do not allow operation of the device by unskilled or unqualified people. - Use of the device in other ways than described in this user manual may cause damage and injury. Ayra cannot be held responsible for any damage or injury caused by improper use.
- Page 5 going to be serviced. Fuses: - The main fuse of this device is to be found on the rear of the device. In most cases, directly next to the power inlet. - Only replace a fuse for a new one with the same type and rating! Do not use a fuse with a higher or lower rating.
- Page 6 Strobe guidelines WARNING! Do not use this device when you, or anybody around you, is oversensitive for intense lighting and flashes. This device is capable of producing intense pulsating light flashes and it is therefore not recommended to use this device near people who suffer from epilepsy as seizures may occur.
-
Page 7: Box Contents
Box contents Box contents 1x Ayra Flash 150 strobe light effect Unit and accessory inspection - If the cable appears broken or has visible damage, do not use it. - If the unit is not going to be used for a longer period of time, disconnect it from the power supply and store it in a dust-free environment. -
Page 8: Device Overview
Device overview 1. light output (and glass lens) 2. mounting bracket with tightening knobs 3. on/off switch 4. power cable 5. strobe speed adjustment 6. safety eye 7. fuse compartment 8. ventilation slots Any information and illustrations shown in this user manual are subject to change without further notice. User manual version: 1.0 Creation date + author initials: 03-11-2015 RV Revision date + author initials: -... - Page 9 Installing the system in a standing position The Flash 150 is mainly used for party lighting and can be placed directly on a flat surface such as a table or counter. Please ensure that the device is positioned safely and the power cord is installed properly. Accidents may happen if the power cord is hanging freely, as it could be pulled by small children, for instance, causing the device to fall down.
- Page 10 advises cleaning the mirror and lens with a fine brush, while removing dust and/or dirt with a vacuum cleaner. Avoid touching the lens with your bare fingers, to prevent fingerprints on the optics. Check-up To prevent dangerous situations, make sure your fixture is in optimal condition before using it. Check your fixture frequently by using the following check list: - All screws must be mounted tightly.
-
Page 11: Technical Specifications
Technical specifications powerful analogue party strobe lighting 150W discharge tube reflector installed for optimal light intensity glass lens intense, pulsating white beams of light fill the entire room! creates the well-known slow motion effect variable strobe speed adjustment strobe speed: 1 – 10 Hz (flashes per second) mounting bracket pre-installed eyebolt for optional safety cable installed on/off switch...
Need help?
Do you have a question about the Flash 150 and is the answer not in the manual?
Questions and answers