Dmb19 Board Block-2; Dmb19 Board - Sony HCD-SLK20D Service Manual

2-6.

DMB19 BOARD BLOCK-2

Note 3: When you install the wire (flat type), please
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight
to the interior.
connector
wire wire
(flat type) (flat type)
2-7.

DMB19 BOARD

Note 1: When you install the wire (flat type), please
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight
to the interior.
connector
wire wire
(flat type) (flat type)
Note 4: Do not insert the wire (flat type) in the same amount of
NG
Insert is incline.
connector
Note 1: Please spread a sheet under a unit
not to injure front panel.
Note 2: Do not insert the wire (flat type) in the same amount of
NG
Insert is incline.
connector
2
4 wire (flat type) (7 core)
(CN202)
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
6 DMB19 board block
3 connector
(CN201)
– Rear bottom view –
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
3 holder (DMB)
5 DMB19 board
1 four screws
(BV3)
– DMB19 board block rear bottom view –
HCD-SLK10D/SLK20D
5 connector (CN1105)
Note 2: When you remove the connector,
it is necessary to note it because
it is very hard.
4 wire (flat type) (13 core)
(CN1109)
2
1 two hooks
‡ :ire VettiQJ
DMB19 board
tape wire (flat type) (7 core)
13