Touch Panel Board - Sony HCD-SLK20D Service Manual

2-17. TOUCH PANEL BOARD

5 wire (flat type) (11 core)
(CN801)
Note 2: When you insert the wire (flat type) (11 core)
in CN801 on TOUCH PANEL board, it is not
necessary to make a mistake in the terminal
side of the wire (flat type) (11 core).
‡ :ire VettinJ
tape
TOUCH PANEL board
Note 3: When you install the wire (flat type), please
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight
to the interior.
connector
wire
(flat type)
Note 4: Do not insert the wire (flat type) in the same amount of
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
‡ :ire VettinJ
TOUCH PANEL board
terminal side
NG
Insert is incline.
connector
wire
(flat type)
holder (sensor)
tape
– Front panel inner view –
HCD-SLK10D/SLK20D
1 five screws
(BVTP2.6)
3 holder (sensor)
6 TOUCH PANEL board
4
2 two claws
– Rear bottom view –
Note 1: Please spread a sheet under a unit
not to injure front panel.
tape
21