2-9.
MD BLOCK
3 MD block
Note 2: When you installing the cover (CDM)
block, match the position of three
ditches.
ditches
Note 1: Please spread a sheet under a unit
not to injure front panel.
2-10. POWER BLOCK
Note: Please spread a sheet under a unit
– Rear bottom view –
2 screw
(BVTP2.6)
4 power block
not to injure front panel.
Note 3: When you install the wire (flat type), please
Insert is straight
to the interior.
wire
1
(flat type)
ditches
2 wire (flat type) (9 core)
(CN703)
ditches
Note 4: Do not insert the wire (flat type) in the same amount of
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
3 clamp (L35)
2 screw
(BVTP2.6)
3 clamp (L35)
1 connector
(CN900)
– Rear bottom view –
HCD-SLK10D/SLK20D
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
NG
Insert is incline.
connector
connector
wire
(flat type)
‡ :ire VettiQJ
clamp (L35)
MAIN board
bottom side
15