Holder (Jack) Block - Sony HCD-SLK20D Service Manual

HCD-SLK10D/SLK20D
2-8.

HOLDER (JACK) BLOCK

Note 2: When you install the wire (flat type), please
install them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight
to the interior.
connector
wire wire
(flat type) (flat type)
Note 3: Do not insert the wire (flat type) in the same amount of
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
‡ :ire VettiQJ
80 mm
TERMINAL board
clamp (L35)
filter clamp
(ferrite core)
tape
14
6 screw
7 holder (jack) block
NG
Insert is incline.
connector
Note 1: Please spread a sheet under a unit
not to injure front panel.
– Rear bottom view –
filter clamp (ferrite core)
tape
(BVTP2.6)
1 Lift up the lead pin.
3 Lift up the
TERMINAL board
cover (CDM) 86S
4 connector
(SLK10D: CN601/
SLK20D: CN603)
5 connector
(SLK10D: CN602/
SLK20D: CN604)
2 wire (flat type)
(7 core)
(CN705)
clamp (L35).
lead pin
cover (CDM) 86S
lead pin
JACK board