Dmb19 Board Block-1 - Sony HCD-SLK20D Service Manual

HCD-SLK10D/SLK20D
2-5.

DMB19 BOARD BLOCK-1

Note 2: Before disconnecting the wire (fl at type) (24 core) of optical pick-up block, solder the short-land.
1 Solder the short-land.
Note 3: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the flexible flat cable 24P.
Note 4: When you install the flat cable, please install
them correctly.
There is a possibility that this machine damages
when not correctly installing it.
OK
Insert is straight
to the interior.
connector
flat cable flat cable
‡ :LUH VHWWLQJ
12
3 flexible flat cable (5 core)
4 connector
(CN601)
6 wire (flat type) (7 core)
(CN001)
Note 1: Please spread a sheet under a unit
NG
Insert is incline.
connector
Note 5: Do not insert the wire (flat type) in the same amount of
tape
(CN4601)
not to injure front panel.
– Rear bottom view –
connector by mistake. Refer to "2-21. HOW TO BEND
WIRE (FLAT TYPE)" (page 24) and "5-1. FLAME
PRINTED WIRING BOARDS" (page 31) for details.
2 flexible flat cable (5 core)
(CN1107)
5 flexible flat cable 24P
(CN101)
tape