Installing The Modem In The Remote; Back Of Remote Board - Culligan CTM Series Installation, Operation, And Service Instructions With Parts Lists

Installing the Modem In the Remote

Open the remote monitor housing by removing the two screws and squeezing the sides of the monitor housing slightly.
Insert the modem board (P/N 01020747) into the socket on the back of the remote board (see Figure 50). Make sure that
all of the pins in all four connectors are aligned and make sure the modem is fully seated into all of the sockets. Snap the
two halves of the remote housing back together using light finger pressure and insert the two screws.
Figure 50. Back of remote board.
Cat. No. 01029401
Installing Accessories 39